Rake issues

[garrety]

I have two issues with the rake that i would like addressed.

#1  when I input a rake on an elevation, the far right end jamb of the elevation is shown to be a little taller than where the rake should connect to.  The rake I specifically input into the elevation spanned from panel 1 to panel 3, from 100" to 80". (Elevation is 100" W x 100" H, 3 equal panels)
 
               Why does this not get drawn in correctly?

#2  After drawing in this rake onto my elevation, it does not show the daylight dimensions correctly.  In the example above there should be at (6) daylight dimensions shown on the left.   
           

               What can be done about this issue?

[GDS-Staff]

Try installing the v15.1.17 patch. We have tried to fix the rake bugs that were in previous versions. Let us know if there is still a problem after installing this version.